Sherco Ignition Timing, Rev.0902 1Sherco Ignition Timing GuideThis guide is designed to provide the Sherco owner with instructions on how to check and
Sherco Ignition Timing, Rev.0902 10Check the timing using a dial indictor and timing pinTDC chisel markFactory mark on flywheelRemove the spark plug b
Sherco Ignition Timing, Rev.0902 11Check timing, cont.Hand-rotate the flywheel clockwise, watching the dial indicator needle. When it is close to the
Sherco Ignition Timing, Rev.0902 12Change timingRemove the timing pin and the flywheel.To advancethe timing, loosen the three bolts of the stator plat
Sherco Ignition Timing, Rev.0902 13ReassemblyGenerally, reassembly is the same as assembly, but performed in reverse order.Remove the dial indicator a
Sherco Ignition Timing, Rev.0902 14Reassembly, cont.Reinstall the ignition cover. Apply anti-seize to the three retaining bolts. Do not over- tighten
Sherco Ignition Timing, Rev.0902 15Changing ignition timing without using a dial indicator1. Follow Steps 1 through 10.2. Refer to Step 16 (page 12)
Sherco Ignition Timing, Rev.0902 16Motorcycle Timing GageToolSource #: 91545 Manufacturer #: 6491 Manufacturer: Central Tools, Inc This item is availa
Sherco Ignition Timing, Rev.0902 2Ignition Timing CommentsFor general purpose use, we recommend maintaining the factory ignition timing setting and ad
Sherco Ignition Timing, Rev.0902 3Ignition Timing Comments, continuedWhy Retard the Timing Beyond the Factory Setting?Retarding creates a softer low-e
Sherco Ignition Timing, Rev.0902 4Factory Ignition Timing Specifications3.0mm3.0mm3.0mm3.0mm20033.8mm3.8mm3.1mm3.0mm20022.7mm2.5mm3.1mm3.0mm20012.7mm2
Sherco Ignition Timing, Rev.0902 5Remove gear shift lever bolt Remove ignition coverRemove the gear shift lever bolt by using a 5mm Allen wrench. Inse
Sherco Ignition Timing, Rev.0902 6Glue gasket to cover Remove flywheelChisel marksFactory paint markInspect the rubber ring gasket for cracks or cuts
Sherco Ignition Timing, Rev.0902 7Remove the flywheel retaining nut using a small impact tool fitted with a 19mm (3/4”) socket. Note that there is no
Sherco Ignition Timing, Rev.0902 8Remove flywheel, cont.3 Bolts3 SlotsHold the flywheel removal tool with either an adjustable wrench as shown, or a 2
Sherco Ignition Timing, Rev.0902 9Mark factory timing settingChisel markTap a straight, sharp chisel mark across the stator plate and its fixing brack
Commentaires sur ces manuels